Cleaning of body and shell
Use only dry paper towel to clean the body shell, lid cover, and the inside
of the hopper.
Cleaning of the discharge tube
Use dry brush and dry paper towel to clear the in- and outside of the
discharge tube from any coffee particles.
Cleaning of the hopper magnet
Dismantle hopper, cover plate and lid cover. Use dry paper towel and/or brush
to clear the hopper and built-in magnet from any coffee particles.
Remove stationary disc flange by releasing screws.
Use dry paper towel and brush to clear the grinding chamber and grinding
discs from any coffee particles.
Make sure that both mating surfaces of stationary disc flange and grinding
chamber are absolutely clean before reassembly. Failure to do so will result in
inconsistent grinds.
Reassemble parts in reverse sequence. Tighten all screws.
Retighten screws of the stationary disc flange. For this purpose, the cover
including the hopper must be dismantled and then re-fitted.
Perform basic calibration according to the calibration instructions provided
here.
