ditting grinders MUST TURN COUNTER-CLOCKWISE. If the grinder
turns clockwise, the ground coffee will not come out and WILL CLOG the grinder.
To check for direction, turn the machine on for a moment and then turn
it off. As the motor is slowing down, look down through the hopper base opening
at the turning nut, and make sure it is turning counter-clockwise. If it
is not, do the following according to your grinder model: (For safety, be
cautious when looking down into the hopper when the grinder is turned on. Make
sure no article of clothing, hair or anything else will fall into the machine or
accidentally get caught in the machine. As with all equipment, use caution and
common sense while operating or performing maintenance procedures).
Models 804 / 903 / 1203 - 110 Volt Application Grinders
This is needed ONLY if a service person worked on the base wiring and did not
wire the motor properly):
From the motor, there are two sets of wire going to the base terminal block.
You must have an Ohmmeter to check the resistance of the pairs of wires.
