1.
UNPLUG THE
COFFEE GRINDER.
2.
Remove the four screws holding the lid/cover assembly and remove it with
the hopper.
a.
On 804
model grinders,
loosen the right rear STOP lock.
b.
Hold the hopper assembly, twist it 30° counter-clockwise and lift.
3.
Remove the screws that hold the top stationary disc flange.
a.
Pull out the stationary disc and set it aside. If the stationary disc
does not come out easily, tap the circumference where the bolts are located with
the handle of your screwdriver. This should loosen any coffee grinds that may be
wedged between the disc and the grinding housing.
4.
Loosen the screw in the center of the adjusting knob (on the right side
of the machine) and slowly remove the screw, the aluminum backing plate, and the
spring behind it.
a.
Unscrew (counter-clockwise) the adjusting gear/cone and set aside.
5.
Remove the center bolt holding the lower rotating disc. You need to place
the soft handle of a pair of pliers in the opening of the grinding chamber
where the coffee goes out to the discharge tube to prevent the rotating disc
from moving.
a.
Take out the washer behind the bolt and replace the bolt in the hole
(finger tight).
6.
Take a large wood dowel (or a piece of hard wood), place it on the head
of the center bolt and hit it with a hammer (hard, if need be) to push away the
cone tipped shaft from the lower rotating plate. The rotating disc is press-fit
on the motor shaft.
7.
Remove the rotating plate and replace it with the new one.
a.
Put some mineral oil on the new felt gasket to lubricate it and to make
the installation easier. DO NOT USE OTHER OILS OR GREASES. Guide the disc into
the housing.
Do not force it, or you could damage the felt seal.
8.
Remove the center bolt, replace the washer that you had taken out, and
tighten the bolt back in place. Place the handle of the pliers back into the
outlet hole and tighten the center bolt.
9.
Reinstall the adjusting gear/cone in the grinder and turn it clockwise
until the rotating plate’s wings clear the grinding housing and the lower plate
spins freely.
10.
Clean the mating surfaces free from dirt and coffee, replace the top
stationary disc and install and tighten the screws.
11.
Replace the cover assembly with the hopper.
12.
Plug the grinder into the outlet.
13.
CALIBRATE
AND ADJUST THE GRINDER FOR PROPER GRIND.
